仿古门窗一般都是刷一些复古的漆,其实也不是说所有的仿古门窗都是刷复古的漆,这个其实有时候是需要根据用料来决定的,一般的仿古门窗刷什么颜色就用什么颜色的漆配。
Antique doors are generally some retro paint brush, but also not to say that all the doors and windows are antique retro paint brush, this is in fact sometimes need to decide according to the materials, what color general antique doors brush what color to paint with.
仿古门窗木材:应选用一、二等红白松或材质相似的木材,夹板门的面板采用五层优质胶合板或中密度纤维板;油漆:采用聚酯漆;使用耐水、无毒型胶粘剂。
Antique wood doors and windows should be used: one or two red and white pine wood or similar material, plywood door panel with five layers of plywood or MDF; paint with polyester paint; use a waterproof, non-toxic adhesive.
二、大于1.5m2的玻璃门应采用厚度 5mm的安全玻璃。宽度大于1m 的仿古门窗,合页应按"上二下一"的要求安装,中间合页的位置应处于门框高度的2/3处。合页安装前,门框与门扇应双面开槽,注意合页的安装方向。 三、门应采用塑料胶带粘贴保护,分类侧放,防止受力变形。
Two, more than 1.5m2 of the glass door should adopt the thickness of 5mm safety glass. Width of more than 1m of the antique doors, hinges should be installed according to the "two a" requirement, the middle hinge position should be in the frame of 2/3 height. Before the installation of the hinge, door frame and the door leaf should be double slotted, pay attention to the installation direction of the hinge. Three, the door should be used to protect the plastic tape, the classification of side to prevent deformation.
四、门装入洞口应横平竖直,外框与洞口应弹性连接牢固,不得将门外框直接埋入墙体。
Four, the door into the mouth should be installed vertically, and the frame should be firmly connected with the elastic door frame, may not be directly buried in the wall.
五、防腐处理:若设计无要求时,门侧边、底部顶部与墙体连接部位可涂刷如橡胶型防腐涂料或涂刷聚丙乙烯树脂保护装。
Five, anti-corrosion treatment: if there is no design requirement, side edge and the bottom of the top wall and connecting parts such as rubber brush type anticorrosion coating or coating polystyrene resin protective equipment.
更多仿古门窗知识,请阅读本网站
More antique door and window knowledge, please read this website